Printing multiples of the same board

Hi. I've been trying to figure out how to duplicate my boards so that I can print and etch multiples of the same board? I've tried exporting as an image, screen shotting etc. etc. but I can't say I've been succsessful. How do I accomplish this?

e14 Contributor over 13 years ago

On 01/21/2013 08:58 PM, Tor-Arne Forsmo wrote:
Hi. I've been trying to figure out how to duplicate my boards so that I can print and etch multiples of the same board? I've tried exporting as an image, screen shotting etc. etc. but I can't say I've been succsessful. How do I accomplish this?

Eagle 5.x:

In PCB window: Select all components and cut. Create new PCB. Paste as
many times you like. Print.

Note that you must do this in same PCB editor window. You cannot copy
from one and paste to other(?).
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Plecto over 13 years ago in reply to e14 Contributor

I actually figured it out right after I made the thread. I just close the schematic and then block copy my board
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
e14 Contributor over 13 years ago

File > Print

Select Blacken and Mirror

Print

Repeat x number of times where x is the number of PCBs you wish to etch.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel