Actions
Forum Thread Details
  • State Suggested Answer
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 166 subscribers
  • Views 245 views
  • Users 0 members are here
Related

How can I create 0.05 inch pinheaders?

Former Member

Hi

 

Now, I want to use 0.05 inch pinheaders the diameter of which is about 8mm and the diameter of drill is 0.65mm.

Although I create such pin, the specification is not applied in board (the diameter doesn't become smaller than about 10mm).

Why does this happen?

Please tell me.

 

I'm using EAGLE 7.1.0.

 

Best regards.

Parents
  • 0

    On 08.02.2016 18:43, Yu Ishikawa wrote:

    Hi

     

    Now, I want to use 0.05 inch pinheaders the diameter of which is about

    8mm and the diameter of drill is 0.65mm.

    Although I create such pin, the specification is not applied in board

    (the diameter doesn't become smaller than about 10mm).

    Why does this happen?

    Please tell me.

     

    I'm using EAGLE 7.1.0.

     

    Best regards.

     

    Some dimensions are goverened by DRC settings. Also note that net

    classes contain some DRC settings for specific classes.

     

     

Reply
  • 0

    On 08.02.2016 18:43, Yu Ishikawa wrote:

    Hi

     

    Now, I want to use 0.05 inch pinheaders the diameter of which is about

    8mm and the diameter of drill is 0.65mm.

    Although I create such pin, the specification is not applied in board

    (the diameter doesn't become smaller than about 10mm).

    Why does this happen?

    Please tell me.

     

    I'm using EAGLE 7.1.0.

     

    Best regards.

     

    Some dimensions are goverened by DRC settings. Also note that net

    classes contain some DRC settings for specific classes.

     

     

Children