Non-visable remnant?

Question

Sometime during a PCB design using the pro version of Eagle 6.5, something happened to cause the extents of the design to increase drastically. The board out line is approximately 0.6 X 2.5 inches, but when I do a zoom to fit, the visable page zooms out to include a significant area (39" X 80"). I thought there might be a remnant on a layer placed way outside the board outline, but attempts to do a block delete finds nothing.

Generating Gerber files also include this extended area!

Any one know how to delete all outside the board outline, or anything that would cause this issue?

Thanks for the group's help

rachaelp · Accepted Answer

Hi Jerry, You've actually had two replies in the EAGLE Central mirror but unfortunately it looks like Element 14 have managed to break the link again.... I'll paste both messages below for you: Morten Leikvoll wrote: On 18.08.2016 16:22, Jerry Robinson wrote: > Sometime during a PCB design using the pro version of Eagle 6.5, something happened to cause the extents of the design to increase drastically. The board out line is approximately 0.6 X 2.5 inches, but when I do a zoom to fit, the visable page zooms out to include a significant area (39" X 80"). I thought there might be a remnant on a layer placed way outside the board outline, but attempts to do a block delete finds nothing. > > Generating Gerber files also include this extended area! > > Any one know how to delete all outside the board outline, or anything that would cause this issue? > > Thanks for the group's help > > -- > To view any images and attachments in this post, visit: > https://www.element14.com/community/message/203935 > Try this.. Show all layers. Group a window with all the good stuff. Cut/Delete it! (Yes, dont worry, you can undo or exit without save to get back). Then do zoom to fit and see what it is.. Then note down the coord, and u And I wrote: Hi Jerry, Did you turn all the layers on when you tried to do the block delete? It could be something an any layer at all so that's something to try. Alternatively you could try opening two copies of EAGLE and copying all your board design data into a new board. Then close all your EAGLE windows down and with a bit of file renaming to make your new .brd file pair with your old .sch file hopefully it should all still back annotate correctly with the original schematics. Again, make sure you have all the layers switched on and only select and copy anything from the area of the board itself. Make sure you take backups and keep them safe before doing anything like that though just to be extra safe. Best Regards, Rachael Try my first suggestion first, then Mortens suggestions and if all else fails then my second suggestion. Best Regards, Rachael

Non-visable remnant?

Top Replies