Why are both nets going to the same end of resistor in board layout?

Autodesk EAGLE

EAGLE User Support (English) Why are both nets going to the same end of resistor in board layout?

Join Autodesk EAGLE to participate - click to join for free!

Actions

Forum Thread Details

State Not Answered
Replies 1 reply
Subscribers 180 subscribers
Views 268 views
Users 0 members are here

bodkin77 over 9 years ago

Hi guys. When I open the board layout view, I have a resistor with the nets coming off the same end. I want the resistor wired correctly (wires on both ends). Thanks

0 rachaelp over 9 years ago

Boyd Roberts wrote on Wed, 28 December 2016 01:30
Hi guys. When I open the board layout view, I have a resistor with the
nets coming off the same end. I want the resistor wired correctly (wires
on both ends). Thanks

Check the name of the net on each side of the resistor in the schematic. I
suspect you have somehow named them the same.

Best Regards,

Rachael

--
http://www.eaglecentral.ca :: The original and best browser access to CadSoft EAGLE support forums. Supported by EAGLE licenses purchased through us :: http://www.eaglelicenses.com
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel