Can't run CAM job

Question

It's been a while since I created a PCB so I probably forgot some things. I have a very simple board for prototyping that's ready for CAM processing. When I try to run the job the progress dialog box will appear then disappear in less than a second. No error messages would show up. I don't know what's going on. I have version 7.7 of the premium edition of Eagle.

autodeskguest · Answer

On 1/25/2017 5:24 PM, Michael Levin wrote: I finally found the gerbers. I enlarged the CAM processor dialog box to full screen and was able to see the full address of where the files were going. How do I designate where I want the files to go? Thanks, Mike -- To view any images and attachments in this post, visit: https://www.element14.com/community/message/214307 Hi Mike, In general, it's easier to use the %N placeholders since these will save the gerbers to the same location as your schematic and board file. This will make the CAM job reusable which in my opinion is simpler. Near the middle you'll a button that says file and field next to it. That's where you specify the location by clicking the file button. If you look at the default jobs you'll notice they all have %N in that field followed by an extension. Let me know if there's anything else I can do for you. Best Regards, Jorge Garcia