Pad Board Diameter vs Device Not The Same

Question

Hi All,

I've created a custom device and set it all up, however the diameter of the pads shown in the package is different to that shown and produced on the PCB board.

As you can see from the image below, the package view pads are smaller than that produced on the board view. They both have the same device.

Does anyone know why this is happening?

autodeskguest · Accepted Answer

On 5/10/2018 2:03 PM, Joel LB wrote:

Hi All,
I've created a custom device and set it all up, however the diameter of the pads shown in the package is different to that shown and produced on the PCB board.
As you can see from the image below, the package view pads are smaller than that produced on the board view. They both have the same device.
Does anyone know why this is happening?

--
To view any images and attachments in this post, visit:
https://www.element14.com/community/message/239247

Check your restring settings in the DRC.

-D

Pad Board Diameter vs Device Not The Same

Top Replies