viewing selected air-wires

autodeskguest over 17 years ago

Is it possible to show only selected signal as air-wires?

I would like to manually route GND on the top of a board and it would be

very helpful to view only those air wires while doing so...

Again, searching the manual I was not able to find anythig on this...

Tony

autodeskguest over 17 years ago

Tony Rolando ha scritto:

Is it possible to show only selected signal as air-wires?

I would like to manually route GND on the top of a board and it would be
very helpful to view only those air wires while doing so...

AFAIK is not possible. You may highlight a signal with the SHOW command
but you can't hide the others.

Marco / iw2nzm
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
autodeskguest over 17 years ago

Tony Rolando wrote:
Is it possible to show only selected signal as air-wires?

I would like to manually route GND on the top of a board and it would be
very helpful to view only those air wires while doing so...

Again, searching the manual I was not able to find anythig on this...

Tony

It will be possible with EAGLE version 5.

Look for the "Re: Airwire hidden option: how to unhide it ?" subject in
the betatest newsgroup.

Tom Sneddon
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
autodeskguest over 17 years ago

when is 5 due?

"Tom Sneddon" <please.reply.only@to.group> wrote in message
news:fqp15d$v0t$1@cheetah.cadsoft.de...
Tony Rolando wrote:
Is it possible to show only selected signal as air-wires?

I would like to manually route GND on the top of a board and it would be
very helpful to view only those air wires while doing so...

Again, searching the manual I was not able to find anythig on this...

Tony

It will be possible with EAGLE version 5.

Look for the "Re: Airwire hidden option: how to unhide it ?" subject in
the betatest newsgroup.

Tom Sneddon
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel