Hello everyone ! I made a two layer pcb in which there are analog & digital
ics so , I made two gnd signals naming AGND & GND . Now I want to connect
these two signals at only at the gnd pin of power connector. When I tried to
naming these signals in Eagle I can give only one name to that net , But
don't want That ? I want separate signals.
"Robert Pearce" <news@bdt-home.demon.co.uk> wrote in message
news:cLgZs57kAILIFwAF@daniel.huneausware.local...
Unless I'm mistaken, that is the answer to almost exactly the opposite
question to what was asked!
You'll get over it!
All information is relavant. 
"Robert Pearce" <news@bdt-home.demon.co.uk> wrote in message
news:cLgZs57kAILIFwAF@daniel.huneausware.local...
Unless I'm mistaken, that is the answer to almost exactly the opposite
question to what was asked!
You'll get over it!
All information is relavant.
