Dear All ...
First, this post is related to my previous post (http://www.element14.com/community/message/30230)
I try to make 2 ps file via cam job
1. First cam job :
a. Layers :
- Center drill (created using drill-aid.ulp)
- Dimmension
b. device : ps
c. style : Pos.Coord
2. second cam job :
a. Layers :
- bottom
- pads
- vias
- Dimmension
b. device : PS-Inverted
c. style : Mirror , Pos.Coord
Since "Dimmension" included in both job , I'm expecting exact same dimmension of both ps file
I make a check for this , by importing both file to same file using Inkscape
The result is different, the first cam job produce slightly smaller dimmension
Differences betwen both is about :
- Horizontal (w) = 0.769 mm
- Vertical (h) = 0.901 mm
A. Picture 1 : Take a look at the dimmension of the 1rst cam job result
( http://i55.tinypic.com/b7dw94.png )
B. Picture 2 : Take a look at the dimmension of the 2nd cam job result
( http://i51.tinypic.com/11gimig.png )
My Question : Is there a way to fix this ?
Sincerely
-bino-