I'm just learning to use Eagle software. I have a schematic that uses a Op-Amp. When I add this part, eagle lets me add 4 op-amp traingles to the schematic, but I can't figure out how to connect wires to V+ (pin 6) and GND (pin 11) because they are not shown on the schamatic diagram. My circuit actually requires +5 volts and -5 volts for the LM324. I'm using a MAX1044 to create the -5 Volts which will go to LM324 pin 11 (ground pin). How do I wire the V+ and GND pins on the ?