Issue with printing circuits for manual etching

Question

Hi!

When I try to configure Eagle so the drill holes are visible and then I route the board, I noticed that the track actually covers the hole. I haven't tried to print it yet but I suppose that the hole won't be visible on the paper.

Is there a way that this issue does not happen?

Thank you!

Morosh · Accepted Answer

On 08/08/2012 15:11, Sergio Poveda wrote:

Hi!

When I try to configure Eagle so the drill holes are visible and then I route the board, I noticed that the track actually covers the hole. I haven't tried to print it yet but I suppose that the hole won't be visible on the paper.

Is there a way that this issue does not happen?

Thank you!

type set --> Misc --> display mode --> real

HTH