move a device in a schematic without stretching wires?

Hello,

I guess the subject says it all. I would like to move a part (say a resistor) that is connected to two nodes (say GND and VDD). Normally when I move the part with the "Move" command, the VDD and GND wires follow the movement. Is it possible to have the resistor move but have it disconnect from GND and VDD?

Thanks

Parents

0 autodeskguest over 11 years ago

On 03.07.2013 08:57, Homer Style wrote:
Hello,
I guess the subject says it all. I would like to move a part (say
a resistor) that is connected to two nodes (say GND and VDD). Normally
when I move the part with the "Move" command, the VDD and GND wires
follow the movement. Is it possible to have the resistor move but have
it disconnect from GND and VDD?

Thanks

--
To view any images and attachments in this post, visit:
http://www.element14.com/community/message/81886#81886

No, this is not possible. The component is tied to its nets, they
have to follow.

--
Mit freundlichen Gruessen / Best regards
Richard Hammerl
CadSoft Support -- hotline@cadsoft.de
FAQ: http://www.cadsoft.de/training/faq/
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 autodeskguest over 11 years ago

On 03.07.2013 08:57, Homer Style wrote:
Hello,
I guess the subject says it all. I would like to move a part (say
a resistor) that is connected to two nodes (say GND and VDD). Normally
when I move the part with the "Move" command, the VDD and GND wires
follow the movement. Is it possible to have the resistor move but have
it disconnect from GND and VDD?

Thanks

--
To view any images and attachments in this post, visit:
http://www.element14.com/community/message/81886#81886

No, this is not possible. The component is tied to its nets, they
have to follow.

--
Mit freundlichen Gruessen / Best regards
Richard Hammerl
CadSoft Support -- hotline@cadsoft.de
FAQ: http://www.cadsoft.de/training/faq/
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 autodeskguest over 11 years ago in reply to autodeskguest

Richard Hammerl <support@cadsoft.de> wrote:
On 03.07.2013 08:57, Homer Style wrote:
Hello,
I guess the subject says it all. I would like to move a part (say
a resistor) that is connected to two nodes (say GND and VDD). Normally
when I move the part with the "Move" command, the VDD and GND wires
follow the movement. Is it possible to have the resistor move but have
it disconnect from GND and VDD?

Thanks

--
To view any images and attachments in this post, visit:
http://www.element14.com/community/message/81886#81886

No, this is not possible. The component is tied to its nets, they
have to follow.

The wires could be broken near the component moved with automatically added
labels on the end...

--
Uwe Bonnes bon@elektron.ikp.physik.tu-darmstadt.de

Institut fuer Kernphysik Schlossgartenstrasse 9 64289 Darmstadt
-
Tel. 06151 162516 -
Fax. 06151 164321 -
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel