Autodesk EAGLE

EAGLE User Support (English) Overlap error on pads

Autodesk EAGLE requires membership for participation - click to join

Actions

Forum Thread Details

State Not Answered
Replies 4 replies
Subscribers 166 subscribers
Views 200 views
Users 0 members are here

Related

Overlap error on pads

julienlaffitte over 10 years ago

Hi

I have some overlap errors on pads of my resistances but i don't understand why. Can anybody help me?

Parents

0 Richard_H over 10 years ago

Hi,

hard to say without further information. Where are these overlap errors? Its not visisble in the image. Please send the board file to CadSoft support. So we can check.

Best regards,
Richard
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 julienlaffitte over 10 years ago in reply to Richard_H

If you look well... it's red on red:) can you see it below?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 julienlaffitte over 10 years ago in reply to Richard_H

If you look well... it's red on red:) can you see it below?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 Richard_H over 10 years ago in reply to julienlaffitte

Hi,

yes I can see the red DRC marks... but this does not help. For checking this I would need your board file....

Regards,
Richard
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 julienlaffitte over 10 years ago in reply to Richard_H

Hi Richard,
Thanks a lot for your answers, i just found where the error was: in the component definition, a little wire on top layer was on the pad.
Best regards
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel