Gerber files

Hello,

I use the freeware version of Eagle. I have made a schematic and board but when i want to make the Gerber files I obtain only the files .cmp and .gpi . I can't have the files .sol .plc .sts .sts and have no error message . Is there a reason ? error or limitation ?

Parents

0 robkeij over 10 years ago

Hello,

which cam file have you selected?

regards,

Rob Keij
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former Member over 10 years ago in reply to robkeij

Hello,

Thank for your answer. Finally I have resolve this problem (due to my poor english).
But I have another problem ( not crucial) : I have had components from library and when I check with DRC I have errors "stop mask" that I don't understand. How correct that?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Former Member over 10 years ago in reply to robkeij

Hello,

Thank for your answer. Finally I have resolve this problem (due to my poor english).
But I have another problem ( not crucial) : I have had components from library and when I check with DRC I have errors "stop mask" that I don't understand. How correct that?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 robkeij over 10 years ago in reply to Former Member

Hello Jean Pierre,

Switch of Tstop (29) to eliminate this errors.

best regards,

Rob Keij
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel