Other than the 10K Resistor that is not connected to anything, I am wondering if anyone can spot any issues with the schematic below?
Other than the 10K Resistor that is not connected to anything, I am wondering if anyone can spot any issues with the schematic below?
Try running a DRC and go to the layout of the board. The air wires will tell you if you have missed any connections or if something is fishy. It always a good ideas to do a quick layout of the board and check if the tacks connect the right pins. I have faced issues where the schematic is good but the footprint was made with the wrong pin numbers e.g. for the TO-23 package.
The dot seem unnecessary and I usually use net names to connect parts together because as the part count rises, the whole thing just becomes confusing.
Hope this helps. 
Try running a DRC and go to the layout of the board. The air wires will tell you if you have missed any connections or if something is fishy. It always a good ideas to do a quick layout of the board and check if the tacks connect the right pins. I have faced issues where the schematic is good but the footprint was made with the wrong pin numbers e.g. for the TO-23 package.
The dot seem unnecessary and I usually use net names to connect parts together because as the part count rises, the whole thing just becomes confusing.
Hope this helps.