First PCB order. Requesting Advice on Electrical Schematic.

Question

Other than the 10K Resistor that is not connected to anything, I am wondering if anyone can spot any issues with the schematic below?

ipv1 · Answer

Try running a DRC and go to the layout of the board. The air wires will tell you if you have missed any connections or if something is fishy. It always a good ideas to do a quick layout of the board and check if the tacks connect the right pins. I have faced issues where the schematic is good but the footprint was made with the wrong pin numbers e.g. for the TO-23 package. The dot seem unnecessary and I usually use net names to connect parts together because as the part count rises, the whole thing just becomes confusing. Hope this helps.

autodeskguest · Answer

Your wires all have a dot at pins. Are they really connected or do they look

connected? Try moving the part and see if the wires follow to confirm. The

dots are not necessary and may be lying. Tbh, I wish Eagle could show a

symbol (an X?) at every unconnected pin to explicitly get rid of this kind

of doubt.