Custom device: cannot route

Question

Hi all,

I have created a new device from scratch: a 60 pin connector.

This device has a tricky part: 6 pins are rounded pins with holes, so I have used SMD pads combined with polygons (to draw the holes) in order to follow datasheet drawings:

After drawing its simbol and package, I'm checking that is working properly in sch and brd files. In the schematic looks working fine. But I have noticed that in the board file the connections made in the schematic are not shown. You can see it in the next (example) image:

In the image above, is quite obvious that something is wrong with the connector: while I use standard devices, the rastsnets appear when I make a new wire, but nothing appears in the connector... I have checked the package: I have used SMD pads (first image);

Also the symbol, standard IO pins and device menu also looks fine...

Does anyone knows what I'm doing wrong???

Thanks in advance!!

mugurumov · Accepted Answer

Hi Warren, You are right, If I move the connector, the wires/nets are not attached to the pins: So I have opened the library again to check what is wrong, seeking the error... And notice that the pins where rotated: Noob failure....So i flipped the pins and now works fine! I guess is how you learn... Thansk @Warren!

autodeskguest · Answer

A couple of things to check. (1)Have you 'connected' the pins and pads in the library? (2)Are the nets connected to the U$1 device? Move it on the schematic and verify the nets stay attached. (Problem happens when you use the wire tool instead of the net tool). HTH Warren -- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.

Custom device: cannot route

Top Replies