Thanks Jorge:
Very good--didn't notice that option before..
Why not add another checkbox option to show the net names & you'd have it
all covered.
It would be very useful to have a highlighter option so when you "show" a
board trace or schematic net it paints the shown trace along with a wide
marker (as though you used an actual highlighter on paper). When a bunch
of traces/nets are very tight and you zoom out to study its path around the
board, just making the razor thin trace bright xxx is still nearly
invisible to spot.
--
Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.