Actions
Forum Thread Details
  • Replies 2 replies
  • Subscribers 179 subscribers
  • Views 293 views
  • Users 0 members are here
Related

Moving piece of wire with label attached

autodeskguest

When moving a single piece of wire with xref label at the end(s), the

label elegantly follows the wire.

 

I wish this can be done for wires with non-xref labels attached too, but

only when both ends of the wire are included in the move. If one end is

stuck to a part or a junction, there is no need to move the label.

 

I realized I do a lot of these, and has to move both wire and label, or

group them before moving.

 

Parents

  • Morten Leikvoll wrote:

     

    When moving a single piece of wire with xref label at the end(s), the

    label elegantly follows the wire.

     

    I wish this can be done for wires with non-xref labels attached too, but

    only when both ends of the wire are included in the move. If one end is

    stuck to a part or a junction, there is no need to move the label.

     

    That would fit seemlessly with the proposals for individual formating

    of xref labels (directional boxes).

    There the 'Box direction' property would only need to allow an

    additional  'noBox' value (besides: in, out, bidirectional, none)

    --

     

    Lorenz

     

Reply

  • Morten Leikvoll wrote:

     

    When moving a single piece of wire with xref label at the end(s), the

    label elegantly follows the wire.

     

    I wish this can be done for wires with non-xref labels attached too, but

    only when both ends of the wire are included in the move. If one end is

    stuck to a part or a junction, there is no need to move the label.

     

    That would fit seemlessly with the proposals for individual formating

    of xref labels (directional boxes).

    There the 'Box direction' property would only need to allow an

    additional  'noBox' value (besides: in, out, bidirectional, none)

    --

     

    Lorenz

     

Children
No Data