Hello, I am very new to Eagle. Can someone tell me if there is a step-by-step guide on creating a schematic / design for an edge card (w/ gold fingers) to be used with an IDC connector? Thanks very much in advance!
Hello, I am very new to Eagle. Can someone tell me if there is a step-by-step guide on creating a schematic / design for an edge card (w/ gold fingers) to be used with an IDC connector? Thanks very much in advance!
Hmmm... Sorry, I didn't look closely. This is not Eagle.
Hi Frank,
Thank you very much for your reply! I will check it out.
Troy.
Hi Frank,
Thank you very much for your reply! I will check it out.
Troy.