Autodesk EAGLE

Forum Metric?

Join Autodesk EAGLE to participate - click to join for free!

Actions

Forum Thread Details

State Verified Answer
Replies 4 replies
Answers 1 answer
Subscribers 172 subscribers
Views 747 views
Users 0 members are here

Related

Metric?

Workshopshed over 10 years ago

How do I switch the UI so that traces, drill sizes etc are in metric rather than imperial?

0 Joop14 over 10 years ago

Andy Clark wrote:

How do I switch the UI so that traces, drill sizes etc are in metric rather than imperial?

In the schematic or board editor type: SET Interface.PreferredUnit 2

See HELP SET for details.

Joop
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Reject Answer

Cancel
0 Workshopshed over 10 years ago in reply to Joop14

Thanks Joop I just tried that, the command was accepted without an error message but does not seem to have made any difference.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Joop14 over 10 years ago in reply to Workshopshed

type: grid mm

Joop
Cancel
Vote Up 0 Vote Down

Sign in to reply

Reject Answer

Cancel
0 Workshopshed over 10 years ago in reply to Joop14

Cheers, that's done it. Many thanks
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel