Actions
Forum Thread Details
  • Locked Locked
  • Replies 5 replies
  • Subscribers 85 subscribers
  • Views 475 views
  • Users 0 members are here
Related
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

CS Polygon pour takes over 30 min

vuk1020

I have a somewhat high complexity board with multiple polygons on different layers. When I pour the polygons sometimes it takes over 30 minutes to do one polygon pour. Is this normal, shouldn't this be more efficient?

Parents

  • It takes that long for ONE polygon?  Do all of them take similar times or is it only one that is very complex?  That time does seem excessive.  I have not done complex polys with CS but the ones I have done have been less than 1 minute.

Reply

  • It takes that long for ONE polygon?  Do all of them take similar times or is it only one that is very complex?  That time does seem excessive.  I have not done complex polys with CS but the ones I have done have been less than 1 minute.

Children
  • in reply to tarribred61

    Yes one polygon can take that long, when there are multiple polygons the problem gets even worse. I have noticed that if you pour them using the "Repour All" command they can sometimes go very fast but it's not consistent. When pouring them individually or through Object inspector it takes a very long time.