Actions
Forum Thread Details
  • State Suggested Answer
  • Locked Locked
  • Replies 7 replies
  • Answers 2 answers
  • Subscribers 91 subscribers
  • Views 3027 views
  • Users 0 members are here
Related
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Solder Mask rule for vias and pads

opeongo73

I would like to have my THole pads with a pull back of 3mils and the vias tented by -1mil. I can't see any way this can be done

as vias don't come up in the selections. You can It select each via and do it but that's crazy.

 

Does anyone know how to do this?

Parents
  • 0

    Sounds like you just need to setup the relevant rules for pads and vias.  To differentiate between through hole and smt pads will probably require a second selection criteria based on hole size (just a thought as I haven't actually tried it.)

Reply
  • 0

    Sounds like you just need to setup the relevant rules for pads and vias.  To differentiate between through hole and smt pads will probably require a second selection criteria based on hole size (just a thought as I haven't actually tried it.)

Children
No Data