This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Board shape from 3D body

Hello,

I was wondering how to define the board shape from an imported 3D body? I know in Altium you can define it while in 3D view but it doesnt seem to be the same in CS.

Thank you,
Louiza

0 bugrobotics over 8 years ago

This was removed with the 1.4 update for some reason. It has been mentioned before here by others and the only response from Altium was that it was going into a hotfix they were working on at the time. 1.4.1 was released and the feature is still not there so not sure what to make of that. Here is a link to the post with instructions on how to download and run 1.3 alongside 1.4: https://www.element14.com/community/message/219683/l/csv14-what-have-i-done-wrong-if-board-shape-define-from-3d-body-is-…
Cancel
Vote Up 0 Vote Down

Cancel
0 louiza_9 over 8 years ago in reply to bugrobotics

Oh I see. Great, thank you for your response!
Cancel
Vote Up 0 Vote Down

Cancel