This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Some wires connected in schematic didn't get reflected in PCB in circuit studio when I updated my PCB document. Please help?

I created a schematic on circuit studio and when I transferred that design on the PCB, some connections of the schematic were missing in PCB. Also, there were no errors generated when I compiled my project. What might be the issue?

I am attaching screenshots of my schematic as well as my PCB document.

Take a look at pin no. 2,3,4,10,11,12 of PCB component T1 which is transformer that can be seen in the schematic.

Also take a look at LT3573 IC in pcb. Its pin no. 4 is connected to resistor R3 in the schematic but it is not connected to R3 in the PCB.

Attachments:

Parents

0 e14softwareuk over 8 years ago

From the PCB try running Tools | Netlist > Clear All Nets and then from the schematic updating the PCB using Home | Project > Update PCB Document. Also are all your schematics and PCBs up to date with any changes you may have made to library parts.
Cancel
Vote Up 0 Vote Down

Cancel
0 vaidyaparth over 8 years ago in reply to e14softwareuk

Sir,
I tried your solution. It is still not reflected.
Cancel
Vote Up 0 Vote Down

Cancel
0 e14softwareuk over 8 years ago in reply to vaidyaparth

There may be some error in library components causing a mismatch. Can you send through the design to software@element14.com and I will be able to take a look for you.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 e14softwareuk over 8 years ago in reply to vaidyaparth

There may be some error in library components causing a mismatch. Can you send through the design to software@element14.com and I will be able to take a look for you.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 vaidyaparth over 8 years ago in reply to e14softwareuk

only schematic file?
Cancel
Vote Up 0 Vote Down

Cancel