This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Setting rules for filling polygons

In the CS documentation, as well as in the videos https://www.youtube.com/watch?v=a8iPHimegdg&feature=youtu.be , filling polygons works correctly. I created a polygon in my project and try to fill it: as a result, only those terminals that have the same NET property are correctly connected to the polygon, and the rest are simply short-circuited.

I guess I do not have any rules? If so, show an example and what to look for?

Thankful in advance for the answer!

Top Replies

e14softwareuk over 7 years ago +1

Hi Sergey. My guess would be your design rules need changing. In the PCB editor use Home | Design Rules to bring up the PCB Rules and Constrains Editor. Check the rules you have for Electrical > Clearance…

0 e14softwareuk over 7 years ago

Hi Sergey. My guess would be your design rules need changing. In the PCB editor use Home | Design Rules to bring up the PCB Rules and Constrains Editor. Check the rules you have for Electrical > Clearance. Make sure to have a Different Nets Only minimum clearance and that the rules in the table below are sensible.
Cancel
Vote Up +1 Vote Down

Cancel
0 bsl76 over 7 years ago in reply to e14softwareuk

Hi Peter.
Thank you! I changed the values in "Clearance", and everything turned out !!!!
Cancel
Vote Up 0 Vote Down

Cancel