Featured Articles
Announcing Pi
Technical Specifications
Raspberry Pi FAQs
Win a Pi
Raspberry Pi Wishlist
Actions
Forum Thread Details
  • Replies 3 replies
  • Subscribers 683 subscribers
  • Views 516 views
  • Users 0 members are here
Related

PiFACE ***and*** GPIO

Former Member

It would be nice to have access to the GPIO pins with an PiFace in place. One solution would be to desolder the 26 pin female connector on the board and replace it by an "header extender" from Adafruit (i.e. a similar female connector with very long soldering pins that go through the board and allow stacking another board (like the Pi -Cobbler)). My question:

1. is the PiFace board single or multiple layer? (multiple layer would be risky to desolder...)

2. while desoldering the existing connector seems easy, resoldering a new one probably means desoldering (and than resoldering) at least the neighbouring relay, to get access to the solder pads.

Is there an easier solution ?

Parents

  • I can't say for sure since information on the Pi-Face seems hard to come by, but from the photos I suspect it's a 4 layer board with internal power and ground.

     

    It'll depend a lot on exactly what you want to connect, and how. The relays look to be relatively higher than a normal pinheader, so stacking another board on top may not work, but connecting a ribbon cable should be ok.

     

    Something I've done before (normally to avoid buying the expensive extended connectors) is to simply solder a two row pinheader on top without even trying to de-solder the existing connector - 26 decent solder joints would be strong enough for most purposes, but you can always fill in with epoxy if you're worried about strength.

     

    Either way, it does look like you might need to remove at least the closest relay to get access.

     

    Desoldering a connector like that from a multi-layer board isn't risky, I've removed the equivalent connector from the Pi itself (just to resolder in onto the bottom) and that's a six layer board. It just takes a little patience, some confidence, a steady hand etc. decent desoldering tools will undoubtably help too.

Reply

  • I can't say for sure since information on the Pi-Face seems hard to come by, but from the photos I suspect it's a 4 layer board with internal power and ground.

     

    It'll depend a lot on exactly what you want to connect, and how. The relays look to be relatively higher than a normal pinheader, so stacking another board on top may not work, but connecting a ribbon cable should be ok.

     

    Something I've done before (normally to avoid buying the expensive extended connectors) is to simply solder a two row pinheader on top without even trying to de-solder the existing connector - 26 decent solder joints would be strong enough for most purposes, but you can always fill in with epoxy if you're worried about strength.

     

    Either way, it does look like you might need to remove at least the closest relay to get access.

     

    Desoldering a connector like that from a multi-layer board isn't risky, I've removed the equivalent connector from the Pi itself (just to resolder in onto the bottom) and that's a six layer board. It just takes a little patience, some confidence, a steady hand etc. decent desoldering tools will undoubtably help too.

Children
No Data