Gpio problem Rpi

What power supply are you using and what current output does it have?

With no power attached and your multimeter set to ohms what is the resistance across the fuse?

If you measure the resistance (with no power) between V+ and ground, do you get a low reading as in less than 100 ohms or much greater?

If you measure your voltage with nothing attached to the GPIO pins do the voltages become correct?

What do you have attached to the GPIOs at the moment and have you checked that for a short?

Are the chips on the Pi (or anywhere for that matter) getting hotter than allowing you to either hold your finger on them, or hold and then remove?

Colin

5v 1.3A  micro usb  power supply

"If you measure your voltage with nothing attached to the GPIO pins do the

voltages become correct?"

Yes that time am getting 3.2v

There is no short circuit am just checked using LED

The circuit is not too hot i can hold the fingure on chips

Every thing else is proper, I can able to see the desktop also

Thanks & Regards

SREEJITH MURALI

sreejith m wrote:

 

5v 1.3A  micro usb  power supply

 

"If you measure your voltage with nothing attached to the GPIO pins do the

voltages become correct?"

 

Yes that time am getting 3.2v

 

There is no short circuit am just checked using LED

 

The circuit is not too hot i can hold the finger on chips

If I understand you correctly, you're saying that if nothing is connected to the GPIO then your RasPi works fine with +3V3 reading 3.2V.  Then when you attach an LED to a GPIO, +3V3 drops to 1V.

If this is the case, it sounds like you may have burned out your LED and converted it into a short circuit.  An LED must have a current-limiting resistor (1K is a good starting value) in series.  Otherwise if you hook it up to +3.3V or more it will give off a very bright light once and then turn into an open circuit or short circuit.  Does your LED still work connecting it between +3.3V and ground, with a 1K current-limiting resistor?

JMO/YMMV

Sounds to me that using your led to check the 3v3 (without a resistor) has caused the polyfuse to operate.

These often need 1 or 2 hours to reset themselves as they are thermal devices.

Often leaving the Pi un-powered overnight fixes it.

Mark

Am using resistor of 270ohms,and it happens 1day back

According to me that is approx 6mA, and should have no effect.

A mystery then, since you appear to have you 3v3 back.

Mark

So 270 ohms is not enough? what should i do now i have tried after 24 hrs now.

So 270 ohms is not enough? what should i do now i have tried after 24 hrs now.

Who told you 270 ohms is not enough?