Help me to setup the software to use the trimak motor

manojroy123 11 months ago

I am trying to install TMCL-IDE for windows. I am getting this error. Please help me in solving it.

manojroy123 11 months ago in reply to Jan Cumps

Which driver board to select and what HW ID to set.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
manojroy123 11 months ago in reply to Jan Cumps

Yes. I am using a 12 volt 8 amp power supply.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Jan Cumps 11 months ago in reply to manojroy123
Did you perform the step by step setup of https://www.analog.com/media/en/technical-documentation/user-guides/tmc9660-3ph-eval-kit-ug.pdf ?

Getting Started

IO Supply Selection

Connecting the Peripherals

TMCL-IDE Quick Start

Turn on the power supply now.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
manojroy123 11 months ago in reply to beacon_dave

UBL Bootstrapping is not showing.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
manojroy123 11 months ago in reply to beacon_dave

Should the display LED on the software that is detecting voltage of the board be red for board to be detected.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
beacon_dave 11 months ago in reply to manojroy123

Perhaps refer to the user manual for guidance.

I'd hazard a guess that they may of meant the 'Enable driver' checkbox

Presumably you completed both the power on

and the bootloader configuration settings

steps successfully before attempting to launch the Wizard Pool ?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
manojroy123 11 months ago in reply to beacon_dave

I have updated firmware with latest version. Still showing same problem. How to enable plugins.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
beacon_dave 11 months ago in reply to manojroy123

May be relevant ?

"I found that most of my plugins were disabled.
Once I enabled them again, I was able to use the wizard."

https://ez.analog.com/motor-control-hardware-platforms2/f/q-a/599152/with-evaluation-board-tmc9660-3ph-evalv1-1-boot-setting-is-good-but-wizard-is-empty
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
manojroy123 11 months ago

After asking on chatgpt it says that you need to configure the motor from Wizard Pool in TMCL-IDE 4.x. But Wizard Pool is not showing any motor. Bellow is the pic of it.

How to know what has caused the error of device not detection on Wizard Pool of the TMCL-IDE 4.x
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
beacon_dave 11 months ago in reply to manojroy123

Perhaps try the latest version ( 3.11.3 ) as the release notes show there were more bug fixes after the initial release for the TMC9660.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel