Most of the problem with the TMCL-IDE 4.7.2 is solved. i need help with respect to starting the motor

Most of the problem with the software and driver board are solved. I was even able to get fault LED on driver board OFF. I am not able to start the motor. Can someone Please guide me in starting the motor.

Top Replies

Jan Cumps 5 days ago in reply to manojroy123 +1

When I'm participating in a road test, I usually set up a slack channel, and invite the fellow roadtesters via the e14 messaging functionality: I created a slack channel for the XXXXX roadtest Only…
cstanton 5 days ago in reply to Jan Cumps +1

We have an element14 Community discord server that we can use for this, alternatively I can spin up a dedicated forum for it. I'd prefer it if these kinds of conversations where somewhere that the element14…
beacon_dave 4 days ago +1

Perhaps check out what the 'Help' menu has to say about the 'Direct mode'. If it anything like previous versions then you should get something like:

Parents

0 beacon_dave 4 days ago

Perhaps check out what the 'Help' menu has to say about the 'Direct mode'.

If it anything like previous versions then you should get something like:
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Cancel
0 manojroy123 4 days ago in reply to beacon_dave

Still no rotation with direct mode
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 beacon_dave 4 days ago in reply to manojroy123

Perhaps also check the motor configuration parameters against the specification of the motor in use.

e.g. if the motor current is set too low then the motor may not run.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 beacon_dave 4 days ago in reply to manojroy123

Perhaps also check the motor configuration parameters against the specification of the motor in use.

e.g. if the motor current is set too low then the motor may not run.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data