Actions
Forum Thread Details
  • Replies 5 replies
  • Subscribers 329 subscribers
  • Views 342 views
  • Users 0 members are here
Related

how to make the filament extrude and stick to the hot bed w/ a i2 printer

Former Member

I'm having problems with making prints. I have a i2 printer and the filament won't extrude and when it comes out its only a little bit or it skips. The filament won't stick to the bed either. Can anyone advice on what I need to do . Thanks

Parents

  • 1. Check if the distance between nozzle and hot bed is too close.

    2. Raise the temperature of extruder.

    3. Check if the nozzle is jammed.

    4. Check if the extruder motor driver is fine.

    5. Try to raise  the power of extruder.

    6. Check if the extruder motor is fine.

    7. Check if the motor wire  is fine.

       If you've tried step 1-7, but still make no sense, maybe the mainboard is not so good.

Reply

  • 1. Check if the distance between nozzle and hot bed is too close.

    2. Raise the temperature of extruder.

    3. Check if the nozzle is jammed.

    4. Check if the extruder motor driver is fine.

    5. Try to raise  the power of extruder.

    6. Check if the extruder motor is fine.

    7. Check if the motor wire  is fine.

       If you've tried step 1-7, but still make no sense, maybe the mainboard is not so good.

Children
No Data