Acetone Vapor Washing for Smoothing out prints

3D Printing

3D Printing Forum Acetone Vapor Washing for Smoothing out prints

Join 3D Printing to participate - click to join for free!

Actions

Forum Thread Details

State Not Answered
Replies 1 reply
Subscribers 329 subscribers
Views 386 views
Users 0 members are here

watchtower96 over 7 years ago

Hi all,

I had a question about using Acetone Vapor Washing techniques to smooth out 3D prints. Does anyone know if their is an optimal layer height that would produce the best results, or if it even matters.

Thanks again!

0 danielw over 7 years ago

Probably a bit late now.

There are a fair few 3D printing you tube videos that cover this, though I can't recall any of them saying a preferred layer height.
I would imagine the smaller the better as there is then less smoothing required, fine details could be lost if left in acetone over a long period of time trying to smooth a rough model.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel