Hi all,
Im outta ideas trying to do this myself. So i hope someone can help./
I have a Ender 3 V2, well it was. Runs a SKR V3 Mini, Pi4 running Klipper, All metal hotend, Dual geqar extruder, plus a multiude of "self print" upgrades and a bunch of software and gadet upgrades.
I have basically replaced every wire on thje machone at one tim or another.
The other day my board crashed "Solid Red light" and no response(?) are cooked. I copuld work around it it just makes alot of noise like original.
But then sees died again, but still with most kmovement
I do notice that bothe the Bed and Hotend temps register around 40c and its about 25c inside here. Klipper is throughing a heatr error, but i cant seem to work out why...
Anyone help??
