It is used for connecting pellet auger Motors to the control board.
also Searching for the suitable crimping pins ( Male / Female )
i already ordered some from Molex, but these are wrong (Looking the same, but wrong measurements)
thx for any help.
Markus
Hi Markus,
The image is not visible because of a bug (for the full detail, it is in this entire thread, no need to read it: Test - JPG - Please Ignore ).
To cut a long story short, if you edit your original message, the image will become visible. This workaround is quickly described here, see the red highlighted text:
Hi Markus,
The image is not visible because of a bug (for the full detail, it is in this entire thread, no need to read it: Test - JPG - Please Ignore ).
To cut a long story short, if you edit your original message, the image will become visible. This workaround is quickly described here, see the red highlighted text:
