Hello everyone,
Let me tell you small story 
While back I have purchased dead "MIller Dynasty 200DX"
After some repairs I have found damage to Boost Board that has internal ground planes burnedout.
I have realisedthat i would need board replacement, however, board is dicontiniued and replacement board will cost me 2000 dollars if I found one.
After fiew hundret emails and phone calls to different suppliers without even one ansfer I have desided recreate board from scrach and make my own.
Fiew month later after reverse engineering pcb to schematic and later on from schematic to PCB i have finally received new boards.
I have solder necesseryparts and run test on new assembled board, however, I have forgot take a maguments from resistor R86
Could some one be so kind and provide value number between pin 2 & 3 on R86?
Here is some pictures from original board and final my creation:
