MakeCode Errors When Coding Sensors for Mi: Node

I am a beginner with the Mi:node and Micro:bit. When using MakeCode I only get error message 927 when coding for Mi:node (V.1) for Micro:bit (V.2). When Mi:node is unplugged from the Micro:bit, MakeCode works for simple coding for Micro:bit. I need to get the Mi:node sensors to work for my son’s STEM project. Any help would be greatly appreciated.

Top Replies

shabaz over 3 years ago +1

There's not enough information, can you insert screenshots of what you're doing and a screenshot of the error message that you see? You might also need to insert a photo or two (high quality, well-lit…
pcnabhani over 3 years ago in reply to pcnabhani +1

I tried to upload everything as PDFs, which were very clear, but they did not appear to come through. I then did them as PNGs. My son then put in the code in python via "insert code". I apologize for the…
pcnabhani over 3 years ago in reply to shabaz +1

Thank you very much. I did upgrade the firmware on the Micro:bit. I did not think that there was any on the Mi:node, but am checking into that. (It appeared that it was an accessory to the Micro:bit without…

Parents

0 pcnabhani over 3 years ago

These are Jpeg attachments of what I tried to attach last night.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 pcnabhani over 3 years ago

These are Jpeg attachments of what I tried to attach last night.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data