Dave Jone's Of The EEVBLOG did some posts on a DIY PSU around a year back. This project is a spin off of that and I made some changes according to my liking and finally made a PCB that I can use. There are still some things that need to be done.
I made a small video for the same which is linked below.
The major differences in this version are as follows:
1. Voltage reference is 4.096V
2. Buttons for interface.
3. Cheaper LCD.
4. 10 1Ohm Resistors
Will share schematic once I get Eagle up and running again.(PC cleaned!)
Lemme know what you think.
Thanks.
IP