Small project Hardware Screws ?

In the US try the McMaster-Carr website and search for sheet metal screw

McMaster carr claims they  don't carry any screws of this size.

This size screws are popular in electronics. They must exist somewhere ?

Anybody  have any idea where to find them. ?

Always a good idea to say where you are on E14 - I'm in UK so my advice may not work for you.

For speed try Amazon - fine for home/prototype use.

https://www.amazon.co.uk/FandWay-Phillips-Rounded-Tapping-Assortment/dp/B081N8QW3M/ref=sr_1_14?dchild=1&keywords=micro+s…

I've used www.shop4fasteners.co.uk with good results.

MK

Always a good idea to say where you are on E14 - I'm in UK so my advice may not work for you.

For speed try Amazon - fine for home/prototype use.

https://www.amazon.co.uk/FandWay-Phillips-Rounded-Tapping-Assortment/dp/B081N8QW3M/ref=sr_1_14?dchild=1&keywords=micro+s…

I've used www.shop4fasteners.co.uk with good results.

MK

Thank you for the suggestion. I'm in California U.S.A

I expect you can get Amazon over there on the West Coast

MK

yes they show a universal kit, but I"m also interested in accurately identifying this exact type and size. That's what no one seems to be able to tell me.

The type of set that michaelkellett mentions looks good, I might buy a set too. If you're creating a new project, you can specify any screw that meets the requirements surely?

If you're looking to replace a screw on an existing project then you might find any near-similar sized screw might work.

These screws are only used for non-critical applications, so it's not surprising if you need to use Amazon/Aliexpress/DIY stores for getting them in a small quantity.

A book I have called "Nuts Bolts and Fasteners" devotes all of three paragraphs to such screws, and that's it. With words to the effect of don't bother using them for any critical application.

General DIY/hobby use or lightweight consumer stuff, sure, but then I don't think you can expect to find it accurately listed in detailed precision at the stores which would typically sell it to individuals. So it's a bit of pot luck if you find it.

You could try contacting screw factories but they might not sell in small quantities.. samples perhaps.