Dear sir,
Hope your are doing good,
I need some guidance on measuring impedance in the instrument using a software.
i have already requested agilent team but they sent VBA file i dont no how to use .VBA files
Can you share some commands which can be sent from labview or hyperterminal so that i can plot data in labview
Thanking you,
Best Regards,
Venugopal
If you have an older version of Microsoft Excel you may be able to open the.vba file.
Ask Agilent ( and remember to cal them Keysight until it changes next 
) again - I'm sure thye can do better than this.
Have you read the programming manual ?
I think the reason that you find it hard to get Labview examples is that the entirely graphical nature of Labview makes it hard (impossible) to print listings in documentation. This is a reason (that you should consider carefully) for never using Labview but I understand that you might have no choice - in which case you have my sympathy.
MK
If you have an older version of Microsoft Excel you may be able to open the.vba file.
Ask Agilent ( and remember to cal them Keysight until it changes next ) again - I'm sure thye can do better than this.
Have you read the programming manual ?
I think the reason that you find it hard to get Labview examples is that the entirely graphical nature of Labview makes it hard (impossible) to print listings in documentation. This is a reason (that you should consider carefully) for never using Labview but I understand that you might have no choice - in which case you have my sympathy.
MK
