I'm looking for Multicomp Pro Oscilloscope SCPI Commands.

Question

Is there a list out there? As far as I can tell, the only SCPI command that works is *IDN?

baldengineer · Answer

So, the normal route you should go is to contact Technical Support via Newark or Premier Farnell. (Which I suggest you do anyway because it should be added to the product listing page.)

That said, I think this pdf is what you're looking for...

Jan Cumps · Answer

The commands are very similar to other oscilloscopes, and match the commands used in most LABview oscilloscope drivers. Good to see that this set is supported by the majority of manufacturers.

I'm looking for Multicomp Pro Oscilloscope SCPI Commands.

Top Replies