For the rework portion of the build, wouldn't it have been easier to gloop some paste flux over the chip leads, then hit all the pins with the iron?
Granted, you'd have to go back with some Isopropyl Alcohol, so it'd take the same amount of time in the end, but there'd be less overall heating on the board.
For the rework portion of the build, wouldn't it have been easier to gloop some paste flux over the chip leads, then hit all the pins with the iron?
Granted, you'd have to go back with some Isopropyl Alcohol, so it'd take the same amount of time in the end, but there'd be less overall heating on the board.
-
Former Member
-
Cancel
-
Vote Up
0
Vote Down
-
-
Sign in to reply
-
More
-
Cancel
Comment-
Former Member
-
Cancel
-
Vote Up
0
Vote Down
-
-
Sign in to reply
-
More
-
Cancel
Children