Related
Recommended
Engagement
  • Author Author: tariq.ahmad
  • Date Created: Date Created
  • Last Updated Last Updated:
  • Views 2163 views
  • Likes 9 likes
  • Comments 11 comments

Upgrading A Christmas Train with Python and Raspberry Pi -- Episode 478

 

Unfortunately, not everything we buy off the shelf is as amazing as it appears. We found this with our Christmas Train. The options were throw it out, and mod it. I didn't really see that as a question...

 

For more information on setting up the RPI headless, head over to Episode 444:  Raspberry Pi 4 DVR  for more info, at around 7:15 in!

element14 presents
Upgrading A Christmas Train with Python and Raspberry Pi

element14 presents  | About David  |  Project Videos

Actions
Parents

  • Great project, I enjoyed the video.

     

    I would go with a socket for the IC install. Less risk of smoking something on the chip during installation.

     

    When the train ran at the end of the video I didn't hear or see your sequence. I was expecting some sound and the train to stop for the 20sec and then resume. Did it do that and I just miss it.

     

    I confess I was multitasking at some points.

  • in reply to colporteur

    That's a very good point about using a socket. For some reason - at no point did it ocur to me as an option. You're quite right though, I had the clearance, so should have used one.

     

    At the end, I had the "motor test script" running. I was also using a shortened track that didn't have the magnet on it (the whole track doesn't fit on the table). That's just the nature of trying to record video with unpredicatable sound and motion happening, it's even worse at betraing continuity, showing where I make misakes and need to cut the video together.

Comment
  • in reply to colporteur

    That's a very good point about using a socket. For some reason - at no point did it ocur to me as an option. You're quite right though, I had the clearance, so should have used one.

     

    At the end, I had the "motor test script" running. I was also using a shortened track that didn't have the magnet on it (the whole track doesn't fit on the table). That's just the nature of trying to record video with unpredicatable sound and motion happening, it's even worse at betraing continuity, showing where I make misakes and need to cut the video together.

Children
  • in reply to a531016

    A note on sockets. I just ordered some PCB motor controller boards. My first choice was sold out so I had to look at an alternate. I couldn't figure out for the life of me, why I hadn't gone with this board. It was cheaper and more compact. When I received the order I discovered why. The board chip was not in a socket! It was SMD. I try and not use these boards when I am prototyping just in case I have to replace the IC.

     

    I enjoyed the project. It is something I would think of myself.