Oh, I see. Thanks for your response. I will try using the RX, TX pins for uploading the code. Also thanks a lot for all of your tutorials. They are always a huge help. :)
On Esp32-S2 IO19&20 are the USB pins for native usb, while all the old ESp32 chip DO NOT HAVE ANY native USB support! The esp32-Wroom-32 is an outdated legacy module, you can of course use it to build stuff, but be aware of the differences to the newer modules!
I am trying to use the symbol for ESP32-WROOM-32 it doesn't have IO20, I have been trying with the datasheet but not sure if the pins are the same. Any suggestions?
3 years later LOL.I just landed in the community. It took me a while to apply what I saw in your video. Here's my first PCB, and I'm proud of it! Thanks again!
Thank you for the video, i have a question to ask, if u could help. I am trying to create a PCB for a wearable with esp32 , but the device must have a battery and a USB to recharge the battery, is it possible to use the same USB for programming the mcu and recharge the battery?
Top Comments