RIoTboard

Forum spdif audio programming

Join RIoTboard to participate - click to join for free!

Actions

Forum Thread Details

State Verified Answer
Replies 3 replies
Subscribers 23 subscribers
Views 466 views
Users 0 members are here

Related

spdif audio programming

kylemills over 11 years ago

i was able to setup the riotboard on Linux after some attempts.

i discovered there is a spdif interface, i want to do some sound programming.

i am new to embedded but have worked on linux, so any pointers will be good.

regards

kyle

Top Replies

tusharp over 11 years ago in reply to kylemills +1 verified

there is freescale document AN3663 on sgtl5000. its a high performance low power codec and highly supported by freescale .

Parents

0 Former Member over 11 years ago

While the i.MX6 is capable of SPDIF, unfortunately it's not been usefully wired up on the RIoTboard. Without sensible access to the hardware side of the SPDIF, there really isn't a lot you can do with it.

The only obviously accessible SPDIF signals would be:

SPDIF_IN on KEY_COL3, but that's already used by HDMI

SPDIF_IN on EIM_D21
SPDIF_OUT on EIM_D22
both of which are used for USB OTG power and would probably require removal of U20.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 kylemills over 11 years ago in reply to Former Member

If SPDIF doesn't work, any other interface i can use .
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 tusharp over 11 years ago in reply to kylemills

there is freescale document AN3663 on sgtl5000.
its a high performance low power codec and highly supported by freescale .
Cancel
Vote Up +1 Vote Down

Sign in to reply

Reject Answer

Cancel

Reply

0 tusharp over 11 years ago in reply to kylemills

there is freescale document AN3663 on sgtl5000.
its a high performance low power codec and highly supported by freescale .
Cancel
Vote Up +1 Vote Down

Sign in to reply

Reject Answer

Cancel

Children

No Data