Dear forum members!
I did a lot of googling on the following problem and finally registered
with this forum.
I have a simple double layer PCB and want to use copper pouring on both
sides using polygons named 'gnd'. Orphans are switched off for both
polygons. However, in some cases it happens that there are isolated "gnd
islands" on both sides connected e.g. by gnd-pin of a connector (so they
are no longer orphans and therefore not omitted).
The problem is that there are NO unrouted air wires, even if the "gnd
islands" are NOT connected to the gnd of the remaining circuit.
Any possible solution is appreciated!
Thanks in advance!
--
Browser access to CadSoft Support Forums at http://www.eaglecentral.ca
