I found when I make a small modification to a project with schematic and
PCB, I'll sometimes end up with an orphaned trace. That is, a short trace
which doesn't go anywhere anymore.
I don't see a setting in the DRC rules to catch this. Is there a way to
automatically find and tag these so i can delete them? Sometimes, they are
short enough that my tired eyes miss them. I'm loathe to rip up and redo
the board as these are typically minor changes to isolated parts.
Thanks
David
--
Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
