Hi,
When I am routing air wires from a via, sometimes I get a yellow 'X'
that doesn't disappear unless I rip up the trace and reroute. Is there
a way to get rid of these some other way?
cheers,
Jamie
Hi,
When I am routing air wires from a via, sometimes I get a yellow 'X'
that doesn't disappear unless I rip up the trace and reroute. Is there
a way to get rid of these some other way?
cheers,
Jamie
Tilmann Reh wrote:
Jamie Morken schrieb:
When I am routing air wires from a via, sometimes I get a yellow 'X'
that doesn't disappear unless I rip up the trace and reroute. Is there
a way to get rid of these some other way?
The "X" is the visual indication for a "vertical" air wire. In earlier
versions, there was only a dot (line of zero length and width), which
was very hard to see.
Hi,
Thanks, on a two layer board I don't understand why there would be a
vertical air wire though 
I think routing vertically is taken
care of by the via!
cheers,
Jamie
Tilmann
Tilmann Reh wrote:
Jamie Morken schrieb:
When I am routing air wires from a via, sometimes I get a yellow 'X'
that doesn't disappear unless I rip up the trace and reroute. Is there
a way to get rid of these some other way?
The "X" is the visual indication for a "vertical" air wire. In earlier
versions, there was only a dot (line of zero length and width), which
was very hard to see.
Hi,
Thanks, on a two layer board I don't understand why there would be a
vertical air wire though I think routing vertically is taken
care of by the via!
cheers,
Jamie
Tilmann
