Am 18.03.2014 11:48, schrieb Jeff Weinberg:
Hi Everyone,
Is there a way to enlarge a schematic to fill a frame? I have tried
everything I can think of to enlarge a small schematic so that it fits
inside the frame to make it a little easier to read when printed.
Any tricks or advice?
Thanks,
Jeff
--
To view any images and attachments in this post, visit:
http://www.element14.com/community/message/106616
Hi,
it is not possible to scale the schematic drawing inside the drawing
frame....
Possible options are:
- draw a new drawing frame in the library with a smaller size
- maybe it helps to delete the drawing frame and use the FRAME command
directly in the schematic editor?
- Use the "area" option in the print dialogue. There you can decide
about the area to be printed. If you print only a drawing frame
first and then use this sheet of paper again for the schematic
you could scale it (sounds a bit complicated, but would be possile...)
Hope this heps.
--
Mit freundlichen Gruessen / Best regards
Richard Hammerl
CadSoft Support -- hotline@cadsoft.de
FAQ: http://www.cadsoft.de/training/faq/