Hi again,
Sorry for the newbie question but I'm really at my wit's end.
I would like to change the diameter of the pads to the passive components on
the already routed board image but the CHANGE command won't let me, even if
the Pads layer is active. All I get is a rude noise, even while the status
bar tells me to left-click on the component I want to change.
Also, it would make my life a lot easier if I could duplicate a section of
the board elsewhere on the same board without having to do it in the
schematic editor. Imagine 2 channels of a stereo system placed side by side
with interconnecting circuitry routed manually. This would look neater, not
to mention making trouble-shooting a lot easier on the actual physical
hardware.
Any help would be gratefully appreciated.
Thanks,
Martin
