One of the things I would like to be able to do is move a part around the
schematic without the nets following the part. Same with MIRROR.
1. Is there a way to do this?
2. Is there a way to change the default of always keeping a part connected
to nets?
3. Is there a way to move a wire end that is connected to a pin so that
the connection is severed? I don't want to delete the wire.
There have been several times I want to mirror a symetrical part so that
the pins conect to opposing wires.
Thanks for any help offered.
Sean
--
There are 10 kinds of people that understand binary.
--
Browser access to CadSoft Support Forums at http://www.eaglecentral.ca
